Smoke v5.41.0-40-gd06d7106c2a FAIL(F) linux 5.10.103-v7l+ [Raspbian GNU/Linux 10.13] ARMv7 Processor rev 3 (v7l) (300 MHz) 4

[Log] [via test-smoke.org] [Raw JSON] [Report JSON] [parsed detail]

Automated smoke report for branch blead 5.41.1 patch d06d7106c2a33ff04a79463396bd9139f41380e3 v5.41.0-40-gd06d7106c2a.
develpi.local: ARMv7 Processor rev 3 (v7l) (300 MHz) (armv7l/4 cpus)
    on        linux 5.10.103-v7l+ [Raspbian GNU/Linux 10.13]
    using     ccache gcc version 8.3.0 (*1)
    using     gcc version 8.3.0 (*2)
    smoketime 11 hours 46 minutes (average 2 hours 56 minutes)

Summary: FAIL(F)

O = OK  F = Failure(s), extended report at the bottom
X = Failure(s) under TEST but not under harness
? = still running or test results not (yet) available
Build failures during:       - = unknown or N/A
c = Configure, m = make, M = make (after miniperl), t = make test-prep

v5.41.0-40-gd06d7106c2a
----------------------- ----------------------------------------------------
O  O                    -Dcc="ccache gcc" (*1)
O  -                    -Dcc="ccache gcc" -Duseithreads (*1)
-  F                    -Dcc="ccache gcc" -Duseithreads (*2)
|  |
|  +------------------  stdio DEBUGGING
+---------------------  stdio

Testsuite was run only with 'harness'

Skipped tests:
    None.

Test failures:
  ../t/re/regex_sets.t (FAILED Non-zero exit status: 9 No plan found in TAP output Non-zero exit status: 9 No plan found in TAP output)
      [stdio] -Dcc="ccache gcc" -Duseithreads DEBUGGING

Compiler messages:
    scope.c: In function ‘Perl_leave_scope’:
    handy.h:99:35: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]
    scope.c:1117:21: note: ‘a2.any_uv’ was declared here
    scope.c:1117:21: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]

About this smoke:
smoking-perl: 5.28.1
smoker-version: 1.72/0.046
timestamp: 2024-06-17T11:16:30Z
tester: perl