Smoke v5.41.0-62-gbc63a9bf6ca PASS linux 5.10.103-v7l+ [Raspbian GNU/Linux 10.13] ARMv7 Processor rev 3 (v7l) (300 MHz) 4

[Log] [via test-smoke.org] [Raw JSON] [Report JSON] [parsed detail]

Automated smoke report for branch blead 5.41.1 patch bc63a9bf6ca7e15be74270f863746b64676c5dbc v5.41.0-62-gbc63a9bf6ca.
develpi.local: ARMv7 Processor rev 3 (v7l) (300 MHz) (armv7l/4 cpus)
    on        linux 5.10.103-v7l+ [Raspbian GNU/Linux 10.13]
    using     ccache gcc version 8.3.0 (*1)
    smoketime 1 hour 58 minutes (average 29 minutes 32 seconds)

Summary: PASS

O = OK  F = Failure(s), extended report at the bottom
X = Failure(s) under TEST but not under harness
? = still running or test results not (yet) available
Build failures during:       - = unknown or N/A
c = Configure, m = make, M = make (after miniperl), t = make test-prep

v5.41.0-62-gbc63a9bf6ca
----------------------- ----------------------------------------------------
O  O                    -Dcc="ccache gcc" (*1)
O  O                    -Dcc="ccache gcc" -Duseithreads (*1)
|  |
|  +------------------  stdio DEBUGGING
+---------------------  stdio

Testsuite was run only with 'harness'

Skipped tests:
    None.

Test failures:
    None.

Compiler messages:
    scope.c: In function ‘Perl_leave_scope’:
    handy.h:99:35: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]
    scope.c:1117:21: note: ‘a2.any_uv’ was declared here
    POSIX.c: In function ‘XS_POSIX_strftime’:
    POSIX.c:5079:6: warning: variable ‘isdst’ set but not used [-Wunused-but-set-variable]
    POSIX.c:5078:6: warning: variable ‘yday’ set but not used [-Wunused-but-set-variable]
    POSIX.c:5077:6: warning: variable ‘wday’ set but not used [-Wunused-but-set-variable]
    scope.c:1117:21: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]

About this smoke:
smoking-perl: 5.28.1
smoker-version: 1.72/0.046
timestamp: 2024-06-22T12:28:20Z
tester: perl