• Reports by commit
  • Recent reports
  • Perl5 CoreSmokeDB
  • Changes
  • Smoke v5.41.1-20-ga518f71bfcc PASS linux 5.10.103-v7l+ [Raspbian GNU/Linux 10.13] ARMv7 Processor rev 3 (v7l) (300 MHz) 4

    Automated smoke report for branch blead 5.41.2 patch a518f71bfcc766c99231d8a207f880a51322b04d v5.41.1-20-ga518f71bfcc.
    develpi.local: ARMv7 Processor rev 3 (v7l) (300 MHz) (armv7l/4 cpus)
        on        linux 5.10.103-v7l+ [Raspbian GNU/Linux 10.13]
        using     ccache gcc version 8.3.0 (*1)
        smoketime 2 hours 5 minutes (average 31 minutes 30 seconds)
    Summary: PASS
    O = OK  F = Failure(s), extended report at the bottom
    X = Failure(s) under TEST but not under harness
    ? = still running or test results not (yet) available
    Build failures during:       - = unknown or N/A
    c = Configure, m = make, M = make (after miniperl), t = make test-prep
    ----------------------- ----------------------------------------------------
    O  O                    -Dcc="ccache gcc" (*1)
    O  O                    -Dcc="ccache gcc" -Duseithreads (*1)
    |  |
    |  +------------------  stdio DEBUGGING
    +---------------------  stdio
    Testsuite was run only with 'harness'
    Skipped tests:
    Test failures:
    Compiler messages:
        scope.c: In function ‘Perl_leave_scope’:
        handy.h:99:35: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]
        scope.c:1117:21: note: ‘a2.any_uv’ was declared here
        scope.c:1117:21: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]

    About this smoke:
    smoking-perl: 5.28.1
    smoker-version: 1.72/0.046
    timestamp: 2024-07-04T07:41:04Z
    tester: perl
    Smoke logs available at http://m-l.org/~perl/smoke/perl/arm-linux-gnueabihf-thread-multi-64int/blead_gcc_quick/loga518f71bfcc766c99231d8a207f880a51322b04d.log.gz