Smoke v5.41.3-130-g07bb160b4b5 FAIL(F) linux 5.10.103-v7l+ [Raspbian GNU/Linux 10.13] ARMv7 Processor rev 3 (v7l) (300 MHz) 4

[Log] [via test-smoke.org] [Raw JSON] [Report JSON] [parsed detail]

Automated smoke report for branch blead 5.41.4 patch 07bb160b4b5315bc311f5673b45494cf5f8b94ef v5.41.3-130-g07bb160b4b5.
develpi.local: ARMv7 Processor rev 3 (v7l) (300 MHz) (armv7l/4 cpus)
    on        linux 5.10.103-v7l+ [Raspbian GNU/Linux 10.13]
    using     ccache gcc version 8.3.0 (*1)
    smoketime 2 hours 37 minutes (average 39 minutes 26 seconds)

Summary: FAIL(F)

O = OK  F = Failure(s), extended report at the bottom
X = Failure(s) under TEST but not under harness
? = still running or test results not (yet) available
Build failures during:       - = unknown or N/A
c = Configure, m = make, M = make (after miniperl), t = make test-prep

v5.41.3-130-g07bb160b4b5
----------------------- ----------------------------------------------------
O  F                    -Dcc="ccache gcc" (*1)
O  F                    -Dcc="ccache gcc" -Duseithreads (*1)
|  |
|  +------------------  stdio DEBUGGING
+---------------------  stdio

Testsuite was run only with 'harness'

Skipped tests:
    None.

Test failures:
  ../cpan/Pod-Simple/t/JustPod_corpus.t (FAILED Non-zero exit status: 116 No plan found in TAP output)
      [stdio] -Dcc="ccache gcc" DEBUGGING

  ../dist/Tie-File/t/31_autodefer.t (FAILED 58-59)
      [stdio] -Dcc="ccache gcc" -Duseithreads DEBUGGING

Compiler messages:
    scope.c: In function ‘Perl_leave_scope’:
    handy.h:99:35: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]
    scope.c:1117:21: note: ‘a2.any_uv’ was declared here
    scope.c:1117:21: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]

About this smoke:
smoking-perl: 5.28.1
smoker-version: 1.72/0.046
timestamp: 2024-09-13T19:22:05Z
tester: perl