Smoke v5.43.4-110-g357c1612e9e FAIL(F) linux 5.10.103-v7l+ [Raspbian GNU/Linux 12.11] ARMv7 Processor rev 3 (v7l) (300 MHz) 4

[Log] [via test-smoke.org] [Raw JSON] [Report JSON] [parsed detail]

Automated smoke report for branch blead 5.43.5 patch 357c1612e9ec9d199d80fed61887fe247775dbe2 v5.43.4-110-g357c1612e9e.
develpi: ARMv7 Processor rev 3 (v7l) (300 MHz) (armv7l/4 cpus)
    on        linux 5.10.103-v7l+ [Raspbian GNU/Linux 12.11]
    using     ccache gcc version 12.2.0 (*1)
    smoketime 2 hours 42 minutes (average 40 minutes 30 seconds)

Summary: FAIL(F)

O = OK  F = Failure(s), extended report at the bottom
X = Failure(s) under TEST but not under harness
? = still running or test results not (yet) available
Build failures during:       - = unknown or N/A
c = Configure, m = make, M = make (after miniperl), t = make test-prep

v5.43.4-110-g357c1612e9e
----------------------- ----------------------------------------------------
O  O                    -Dcc="ccache gcc" (*1)
O  F                    -Dcc="ccache gcc" -Duseithreads (*1)
|  |
|  +------------------  stdio DEBUGGING
+---------------------  stdio

Testsuite was run only with 'harness'

Skipped tests:
    None.

Test failures:
  ../cpan/ExtUtils-Install/t/Installed.t (FAILED Non-zero exit status: 116 Bad plan. You planned 76 tests but ran 43.)
      [stdio] -Dcc="ccache gcc" -Duseithreads DEBUGGING

Compiler messages:
    handy.h: In function ‘Perl_leave_scope’:
    handy.h:95:35: warning: ‘a2.any_uv’ may be used uninitialized [-Wmaybe-uninitialized]
    scope.c:1117:21: note: ‘a2.any_uv’ was declared here

About this smoke:
smoking-perl: 5.36.0
smoker-version: 1.72/0.046
timestamp: 2025-11-12T09:07:52Z
tester: perl