Smoke v5.43.6-30-g117cee861c6 PASS linux 5.10.103-v7l+ [Raspbian GNU/Linux 12.11] ARMv7 Processor rev 3 (v7l) (300 MHz) 4

[Log] [via test-smoke.org] [Raw JSON] [Report JSON] [parsed detail]

Automated smoke report for branch blead 5.43.7 patch 117cee861c630623b0f0f66fd7ca7cd5d8859d98 v5.43.6-30-g117cee861c6.
develpi: ARMv7 Processor rev 3 (v7l) (300 MHz) (armv7l/4 cpus)
    on        linux 5.10.103-v7l+ [Raspbian GNU/Linux 12.11]
    using     ccache gcc version 12.2.0 (*1)
    smoketime 2 hours 28 minutes (average 37 minutes 6 seconds)

Summary: PASS

O = OK  F = Failure(s), extended report at the bottom
X = Failure(s) under TEST but not under harness
? = still running or test results not (yet) available
Build failures during:       - = unknown or N/A
c = Configure, m = make, M = make (after miniperl), t = make test-prep

v5.43.6-30-g117cee861c6
----------------------- ----------------------------------------------------
O  O                    -Dcc="ccache gcc" (*1)
O  O                    -Dcc="ccache gcc" -Duseithreads (*1)
|  |
|  +------------------  stdio DEBUGGING
+---------------------  stdio

Testsuite was run only with 'harness'

Skipped tests:
    None.

Test failures:
    None.

Compiler messages:
    sv_inline.h:689:8: warning: ‘oldsv’ may be used uninitialized [-Wmaybe-uninitialized]
    inline.h: In function ‘Perl_cx_poploop’:
    inline.h:4172:17: note: ‘oldsv’ was declared here
    handy.h: In function ‘Perl_leave_scope’:
    handy.h:95:35: warning: ‘a2.any_uv’ may be used uninitialized [-Wmaybe-uninitialized]
    scope.c:1117:21: note: ‘a2.any_uv’ was declared here

About this smoke:
smoking-perl: 5.36.0
smoker-version: 1.72/0.046
timestamp: 2025-12-24T14:15:40Z
tester: perl